Average Reviews:
(More customer reviews)Another handy piece of equipment from Garmin!
This kit comes in three basic parts; a sensor unit, which is about the size of a matchbox, and two magnets about the size of your pinky nail. Several zip-ties are included for mounting purposes; the entire kit weighs at most a couple of ounces.
Installation is pretty straightforward, but do follow the directions carefully and don't snug down the zip-ties until you're sure you've got all three components just where you want them and have tested the system!
The sensor mounts to the left chain stay with a pair of zip-ties. Garmin thoughtfully added a piece of rubber padding to the bottom of the sensor unit, so it won't rough up your fancy carbon frame or your paint job :)
A single zip-tie attaches the crank magnet to the crank, although I had to use a large (3/4") shim on my FSA crank (which has a curved profile and a hollow back) to place the crank magnet in the proper position for the sensor to "see" it. The spoke magnet clamp has both a round hole and a square hole; make sure you use the right hole for your spoke profile! I mounted mine on a spoke directly opposite the tire valve, just to help keep the wheel in balance.
The sensor unit must be positioned along the chain stay such that it can "see" both the crank magnet as it passes by the cadence sensor (the round part on the side of the sensor unit), and the spoke magnet as it passes the speed sensor (the part that looks like a lever in the picture).
Testing is accomplished by pressing a small button on the sensor unit, which prompts it to flash a red LED, then a green one to indicate that testing is started. As pointed out by another reviewer, the LEDs are hard to see in bright ambient light; I'd recommend testing in a garage if possible. Hi-intensity LEDs would have solved this problem, although I suspect these LEDs were chosen for their low power consumption, so maybe it's a smart design decision after all.
Once the test button is pressed, the next 60 revolutions of the crank should cause the red LED to flash when the crank magnet passes the sensor, while the spoke magnet passing the sensor should generate a green LED flash. If you saw the red/green flash when the button was pressed, but don't see a flash as each magnet passes the sensor, chances are one or both magnets are not properly aligned with the sensor (there are alignment lines on the sensor and both magnets), or the magnets are passing too far from the sensor (this is the problem I encountered and solved with a shim).
When you're sure everything is in the right places, snug the zip-ties and cut them flush. Then set up a screen (typically the Biking screen) on your 305 to display Cadence in one of the data fields, and go ride!
Click Here to see more reviews about: Garmin GSC 10 Speed/Cadence Bike Sensor
A good companion for Garmin's Edge 305 and 305CAD cycle computers and the Garmin Forerunner 305 personal trainer, the GSC 10 monitors your cycling rhythm for up-to-the-minute results and later analysis. The self-calibrating, wireless unit measures both speed (in pedaling strokes per minute) and cadence , then provides feedback to the user for optimal performance. You can later feed the results to Garmin's Training Center software, which helps you tailor your workouts to meet specific goals and objectives.
Like the Garmin heart rate monitor, the GSC 10 attaches easily to your bike, where its sensors detect signals from your wheels and send the information wirelessly to your personal trainer/cycle computer. It's also backed by a one-year warranty.
Get 40% OFF
Click here for more information about Garmin GSC 10 Speed/Cadence Bike Sensor
No comments:
Post a Comment